The feeling that you get after getting tile installation done properly gives a satisfaction that we all seek for while remodelling our home. While you choose to install you tiles by yourself to save some dollars, there are chances of potential mistakes too. This article will be divided into two parts describing steps to be taken, correct tools to be used and pitfalls to look out for in your tile installation projects.
So, lets take a look at first stage of tile installation where you need some tools and other things for your project.
Tools that you need for floor tile preparation
For safety and comfort, you will need Goggles or safety glasses and knee
pads.
For prepping, you need ¼” cement board, backerboard screws, saw and
crack-prevention membrane.
For squaring room, you need tape measure, chalk line, carpenter’s square and hairspray.
Important steps to prep floor for tile installation
Steps explained bellow are essential for successful tile installation in flooring for kitchen, bathroom, mosaic tiles, stone, ceramic tile and more. Tile installation on wall is complex and require some more skills and experience to be done properly because of its vertical nature.
Follow these following steps for successful tile installation at your
home.
Step 1
The initial step for installation of tiles is very important which is prep the subfloor. Every floor require some work to be done either it wood or concrete, the floor moves and flexes with humidity and temperature by time. So, start by removing staples and drive down screws if you find any. Than install a cement backer board for setting up a good base for tile installation.
For concrete subfloor, start with removing old adhesive and fill
cracks with appropriate patch item. Whether wood or concrete, always make sure
if the subfloor is clean and there is no debris remaining.
Step 2
To make the tile installation project go smoothly and to ensure
minimization of waste, make sure to determine starting point and laying out the
tile pattern. There are several types of patterns that you can follow depending
upon the shapes and sizes of the tiles. This must be done prior to starting you
tile installation. However, if you choose a traditional square tiles or linear
pattern, you can save more time as they are easy to install. Determining the
starting point in the room is also very important factor for tile installation
as you would want each tile to be visible in the room too. Measure your room
and determine the center of it and then mark lines with a chalk on the floor to
use them as a guide for installing tiles.
Well, that’s too much right? Installing tiles is not an easy task as
people think. Moreover, the steps explained are not even detailed and there is
much more that should be done while installing tiles. That is why we always
recommend people hiring tile flooring
services in Los Angeles as it requires a lot skills and experience in order
to do everything perfectly.
Comments
Post a Comment